1965 Plymouth Belvedere

1965 Plymouth Belvedere II Been a \'race car\' since 1979.Super Nice, full interior, roll cage, bench seat.lights (in& out) work. 440.055 over, half filled, eagle rods, custom Diamond pistons, thick tops, rings moved down,.043 upper ring, 3mm oil,.990 tool steel pin. 1/2\' pickup, milodon low-profile pan, fluid dampner, roller master chain, LSM roller , inverted flank , 4-7 swap firing order , 286 @ .050 , lift is .706 w/ 1.6 T&D rockers, trend pushrods ball/ball, on fully ported Muscle motor stage 6 heads, 2.19 in, 1.81 ex. Ferrea valves, Isky tool room springs, comp lifters, tit. ret., flow 320 @ 600. M1 full width intake,with a pro systems 4150 flows 1040 cfm. 727 with trans act alum drum, bolt-in sprag, turbo action valve body, 5.1 lever, deep pan, big cooler ,-6 braided lines ,turbo action shifter , 8\' custom PTC converter, alum 1350 drive shaft ( dynotech), super stock springs (old ones 002/003\'s) Dana 60 with 4:30 gear and posi, moser 35 spline axles w/ drive studs. Hole shot wheels, rears custom made for car 12\' wide, Wilwood front disc\'s ( rear\'s in box ), new brake lines, master cyl.,prop valve, org. rad. ( needs modern cooling system) have in box Meiziere remote pump & mounting blocks, motor plated. Springs moved in and rear tubs have been banded. 315 mickey drag radials, 28\' m/t front runner Car has less than 20 miles on drivetrain, went 11.002 @ 124 only time to track with 100 square jets in carb. Needs more fuel, should run 10.60\'s on pump gas !!Trim: IIDoors: 2